Britax safe-n-sound BS0072E-i20133 Instructions For Installation & Use page 51

D. Remove the excess tether strap from pocket and fully
press top tether adjuster button (1) while pulling top
tether strap (2) to slacken as shown. In some vehicles
loosening of the top tether strap may be difficult. If so,
try pushing the restraint against the vehicle seat back
or slightly lifting the restraint to release the tension.
Store loose strap in the storage pocket provided on the
cover.
E. Disengage the attachment clip from upper anchorage
fitting. The child restraint is now disconnected.
Store loose strap in the storage pocket provided on the
cover.
F. To convert the restraint from Rearward Facing mode to
Forward Facing mode, Pull the stabilising bar upward
and away from the seat to unlock and rotate.
G. Rotate the stabilising bar around so that it is in position
at the bottom rear of the seat. Either recline or upright
position may be set by locking into the forward or
rearward slot.
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
Instructions for Installation & Use
2
Pull out to
unlock
Rotate
stabilising bar
51