Britax safe-n-sound BS0072E-i20133 Instructions For Installation & Use page 71

REMOVING CHILD FROM RESTRAINT
A. Push and hold the harness adjustment button while
pulling both shoulder harness straps to slacken harness.
B. Press the red button on harness buckle, both harness
tongues will be released. Insert tongues into tongue
holders to hold straps away from the child. Move
shoulder straps to the side, remove child.
To remove the seat refer to page 70 for ISOFLEX or below
for seatbelt installation.
REMOVE RESTRAINT FROM VEHICLE
FITTED WITH SEATBELT
A. Remove the top tether strap from pocket and fully
press top tether adjuster button (1) while pulling top
tether strap (2) to slacken as shown. In some vehicles
loosening of the top tether strap may be difficult. If so,
try pushing the restraint against the vehicle seat back or
slightly lifting the restraint to release the tension.
B. Disengage the attachment clip from upper anchorage
fitting.
C. Store loose strap in the top tether storage pocket
provided on the cover.
D. Disengage the vehicle seatbelt buckle from any lock-off
devices on both sides of the restraint.
E. Disengage seatbelt from the restraint belt paths. Allow
seatbelt to feed back into seatbelt retractor.
Buckle tongue
holder on both
sides of the
seat. Push
tongue inwards
to engage.
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
Roll up excess
strap and store in
the pocket attached
to the cover to
avoid tripping
when moving the
restraint.
Instructions for Installation & Use
2
71