Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Britax Safe-n-Sound BS4900A-020130 Series
Summary of Contents for Britax Safe-n-Sound BS4900A-020130 Series
- Page 1 BOOSTER SEAT Instructions for Installation & Use Series No. BS4900A-020130 FORWARD FACING 4 years to 8-10 years (approx). IMPORTANT: KEEP THIS BOOKLET IN THE PLACE PROVIDED ON THE CHILD RESTRAINT Instructions for Installation & Use - Series No. BS4900A-020130...
- Page 2 SEATBELT QUICK SETUP SEATBELT QUICK SETUP Unfold Seat Check and adjust headrest Attach top tether to Check and adjust Risk of trapping anchorage SecureGuard™ Device hand/finger Raise/Lower headrest Store excess 30 mm strap in pocket Feed slack to retractor 3. Push back Remove slack 1.
- Page 3 INTRODUCTION INTRODUCTION Được sử dụng với dây nịt an toàn quàng qua vai em nào có vai trên vạch ghi To be used with a lap-sash seatbelt by a child whose shoulders are above the lower shoulder độ cao của vai ở dưới cùng có phần đầu ở vị trí thấp nhất (khoảng 4 tuổi) đến height marker with head restraint in lowest position (approximately 4 years of age) until the khi vai của em cao tới vạch độ...
- Page 4 INTRODUCTION INTRODUCTION Να χρησιμοποιείται με ένα ζώνη ασφαλείας τριών σημείων από ένα παιδί के व ल उस शिशु द् व ारा ले प -से श सीटबे ल ् ट के साथ प् र योग किया जाना चाहिए जिसके कन् ध े कन् ध े के निचले भाग से ऊपर του...
- Page 5 Carefully read all of the instructions for installation in this book. If in doubt about the method - A GROWING CHILD of installation, consult Britax Childcare or agent or a child restraint fitter or, in New Zealand, - THE NEXT SEAT consult the agent for the vehicle.
- Page 6 IMPORTANT : • Protect all webbing from abrasion and cutting by sharp corners and edges. • DO NOT USE WITH JUST A LAP BELT. You must use with lap-sash seat belt, or with a • This restraint must be used facing forward and in conjunction with a lap-sash seat belt or seat belt and child harness.
-
Page 7: Shoulder Height Markers Anda Growing Child
SHOULDER HEIGHT MARKERS AND SHOULDER HEIGHT MARKERS A GROWING CHILD IMPORTANT: Follow this advice. FROM APPROXIMATELY 4 YEARS OF AGE. LOWER SHOULDER HEIGHT MARKER (Marker A) A Child who has outgrown their child restraint with in-built harness will have their shoulders in line or above the lowest shoulder height marker (label A) of this booster seat with the headrest Marker B in the lowest position. -
Page 8: Special Features
SPECIAL FEATURES SPECIAL FEATURES 14 13 Rear View of Booster Seat Front of Vehicle 1. Side Impact Cushion Technology Headrest 6. Seatbase Adjustment knob 11. Headrest Adjustment handle (SICT™) 7. SecureGuard™ Anti Submarining Device 12. Adjustable Top Tether Strap 2. Adjustable Height Headrest 8. -
Page 9: How To Set Up
HOW TO SETUP HOW TO SETUP UNFOLDING THE BOOSTER SEAT ADJUSTING THE HEADREST If the seat is in a folded position, grip the A. The headrest can be adjusted to lock into different height Booster seat back and seat base and unfold locations. - Page 10 HOW TO SETUP HOW TO SETUP ADJUSTING BASE EXTENSION ADJUSTING THE SECUREGUARD™ DEVICE This booster seat has a base extension which can The SecureGuard™ Device crotch strap must be Under booster seat be easily adjusted by rotating the knob. This is to adjusted so that it fits the seatbelt correctly to the accommodate the leg length of larger children.
-
Page 11: How To Install
HOW TO INSTALL HOW TO INSTALL INSTALLING INTO VEHICLE C. Tighten adjustable top tether strap by pulling Pull to remove slack adjusting strap (C) to remove slack, but do not over-tighten causing the restraint base to lift off the A. Position the restraint in the car facing-forward in the vehicle seat. -
Page 12: How To Use
HOW TO USE HOW TO USE USING WITH A LAP-SASH SEATBELT D. Fit the SecureGuard™ Device to the Follow arrows to remove slack lap belt. Correct device adjustment will position the lap belt directly across A. With the Booster Seat installed in the Ensure Sash belt the hips/thighs of the child. - Page 13 HOW TO USE HOW TO USE SETUP CHECKLIST WARNING: A SASH BELT UNDER THE ARM OR BEHIND THE BACK IS DANGEROUS. Adjust headrest so it is close to the shoulders. Seatbelt across the chest and through the sash guides. Lap belt must always be firm on the thighs. The SecureGuard™...
- Page 14 CHILD HARNESS PREPARATION CHILD HARNESS PREPARATION INSTALLING SAFE-N-SOUND PROTECTA PLUS™ HARNESS This booster seat is only approved for use with Safe-n-Sound Protecta PLUS™ child harness WITH EXTENSION STRAP INTO VEHICLE Series 220/2013 and Series BS0220-020133. INSTALLING SAFE-N-SOUND PROTECTA PLUS™CHILD An adjustable extension strap is supplied with the Child Harness. Hook the Safe-n-Sound HARNESS WITHOUT EXTENSION STRAP INTO VEHICLE Protecta PLUS™...
- Page 15 CHILD HARNESS PREPARATION CHILD HARNESS PREPARATION A. Lengthen the Child Harness using the adjuster under the cover (see the Child Harness C. Pull the left hand Harness Strap & Cross Strap Hook the Attachment Clip instructions for the adjustment method). Press the Adjuster button (1) and pull the shoulder back through the opposite shoulder slot.
- Page 16 HOW TO INSTALL CHILD HARNESS HOW TO INSTALL CHILD HARNESS INSTALLATION METHOD CONVERTING A LAP-SASH SEATBELT FOR USE WITH THE If the seating position has a lap only seat belt then no other vehicle seatbelt preparation is CHILD HARNESS. required. If the seating position has a lap-sash seatbelt then it MUST be converted into a lap belt by fitting a Gated 3 bar slide, see page 32.
- Page 17 HOW TO INSTALL CHILD HARNESS HOW TO INSTALL CHILD HARNESS FITTING THE GATED SLIDE TO THE LAP-SASH SEATBELT D. Feed the straps through the gated slide to remove any slack. This has now converted the lap-sash seatbelt so it will act like a lap only seatbelt. A.
- Page 18 HOW TO INSTALL CHILD HARNESS HOW TO INSTALL CHILD HARNESS USING THE CHILD HARNESS USING LAP ONLY SEAT BELT OR CONVERTED LAP-SASH SEATBELT WITH THE CHILD HARNESS Refer to child harness fitting instructions for further details. Install the Child Harness to the booster seat and anchorages as detailed previously (page 28- 29).
- Page 19 HOW TO INSTALL CHILD HARNESS HOW TO REMOVE D. Hook the SecureGuard™ Device over the lap belt When Booster is not being used, secure in position, by engaging seatbelt over the booster seat or store in a safe place. and engage the vehicle seat belt tongue to the buckle.
-
Page 20: Care And Maintenance
Do not use chemicals or cleaning agents. Do not try and place any hardware into a washing machine. ONLY USE BRITAX SAFE-N-SOUND SEAT COVERS AND ACCESSORIES THAT ARE DESIGNED AND TESTED FOR USE WITH THIS PRODUCT. - Page 21 CARE & MAINTENANCE CARE & MAINTENANCE TO REMOVE COVER C. Remove seat base cover by releasing elastic Remove loops from rear of seat base. Feed through the A. Locate and remove all elastic straps from their Plastic Flaps SecureGuard™ Device and the base adjustment hooks/positions.
- Page 22 CARE & MAINTENANCE CARE & MAINTENANCE TO REPLACE COVER C. To replace middle cover, engage plastic Engage flaps at booster wing upper and lower A. To replace base cover, Slide on base cover Plastic Flaps as shown. Do not loop the elastic at and feed SecureGuard™...
- Page 23 If an aftermarket accessory is used that is not recommended by Britax restraint fitting station or traffic authority for preferred position of upper anchorage point.
- Page 24 Extension Strap distance to be measured. Attachment Bolt Locate the upper anchorage point behind the rear Length 300mm (Use BRITAX Safe-n-Sound part 0035). Lock washer seating position. (Consult the car owners handbook for Length 600mm (Use BRITAX Safe-n-Sound part 0036).
-
Page 25: In Case Of Crash
STRUCTURES. WHEN DRILLING 9 MM HOLE DO min. NOT DRILL THROUGH FUEL LINES, FUEL TANKS, All Britax Safe-n-Sound child restraints are manufactured to Australian/New Zealand ELECTRICAL WIRING, OR RADIO SPEAKERS. Standards AS/NZS1754-2013 which require us to advise users of child restraints to WEBBING STRAPS MUST BE PROTECTED FROM "Destroy the entire restraint if it has been in use in a severe crash, even if no damage... - Page 26 The Britax Safe-n-Sound Crash Exchange Program is a voluntary program designed to ensure that our children are safe and that any seat that may have experienced a severe crash is taken out of the market.
- Page 27 The BRITAX trademark are the property of Britax Childcare Holdings Ltd, UK. We reserve the right to alter this product without notice. © 2012-2016 Britax Childcare Pty. Ltd. This product is covered by Australian and overseas patent applications and registered designs.