INSTALLING THE RESTRAINT INTO THE CAR
(USING ISOFLEX CONNECTORS IF SUPPLIED TO THE CHILD RESTRAINT)
To prevent damage to vehicle seat it may be necessary to remove or open a trim covering the ISOFIX low
anchorages.
A. Setup the seat for rear-facing
mode by positioning the
stabilising bar as described on
page 27 and 28.
B. Locate the ISOFIX Low
Anchorages in the vehicle rear
seat. If you cannot locate the
ISOFIX bars, check your vehicle
owners manual.
C. With the restraint upright, remove both ISOFLEX
connectors from storage on the upper sides of the
restraint by pressing the red release button as shown.
The location may be
identified by one of the
following symbols.
ISOFIX low anchors in the
vehicle rear seat
Storage Pin
Instructions for Installation & Use
35