Britax safe-n-sound BS0072E-i20133 Instructions For Installation & Use page 72

DISCONNECT TOP TETHER AND
ISOFLEX CONNECTORS
To store the ISOFLEX connectors on the inside of
the seat wings.
A. Press the ISOFLEX strap adjuster button to
release tension on the straps.
B. Press each of the red release buttons on the
ISOFLEX connectors and remove them from
the vehicle ISOFIX low anchorages.
C. Fully lengthen the ISOFLEX strap and engage
each ISOFLEX connector onto its storage pin.
Remove slack but do not tighten. The storage
pin may be damaged if the strap is tightened.
D. Remove the excess tether strap from pocket
and fully press top tether adjuster button (1)
while pulling top tether strap (2) to slacken as
shown. In some vehicles loosening of the top
tether strap may be difficult. If so, try pushing
the restraint against the vehicle seat back
or slightly lifting the restraint to release the
tension.
E. Disengage the attachment clip from upper
anchorage fitting.
Roll up and store the loose top tether strap
in the pocket provided on the cover to avoid
tripping.
72
Instructions for Installation & Use
Storage Pin
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
Roll up excess
strap and store in
the pocket attached
to the cover to
avoid tripping
when moving the
restraint.
2