Table of Contents
Advertisement
im Vertrieb von
Maintenance and Modifications, cont'd
9.
On the underside of the table, remove the two bolts that
secure the clamshell to the surface mount enclosure and
remove the clamshell (figure 3-5).
Yellow Shipping
Restraints
REMOVE
IEC Power Cord
RJ-45 Connectors
Figure 3-5 — Removing the HSA 822M from the table
www.camboard.de
3-8
HSA 822M • Maintenance and Modifications
HSA 822
Enclosure
IN PU
SE
T
LE
CT
CO
MP
AU
UT
DI O
ER
Mounting
Surface
AAP Cables
Clamshell
Motion Control
Connector
Network (TP)
Cables
Flat Washer
Full Thread
Mounting Bolts
CAMBOARD Electronics
Tel. 07131 911201
Fax 07131 911203
10.
From the underside of the enclosure, reach into the cable
access holes (figure 3-1 on page 3-2, item
tie wraps (
) that route the AAP cables and network
5
(CAT 6) cables inside the enclosure. Carefully pull the
cables through and out the bottom of the HSA.
11.
Lift the enclosure out of the table.
The flanged edges of the top of the surface enclosure
are sharp when the HSA is removed from the table.
Exercise caution when handling to prevent personal
injury.
CAUTION
The flanged edges of the top of the surface enclosure
are bevelled to an ultra-fine thickness of less than
0.04 (4/100)" (approximately 1 mm). These edges
are soft and can be easily nicked or bent. Exercise
caution when handling and mounting the
enclosure. Mishandling can damage the appearance
of the enclosure.
The surfaces of the HSA enclosure have screws and
other protruding hardware that could damage fine
furniture. Do not rest the enclosure on unprotected
furniture.
12.
Remove and retain the four screws in the corners of each
side's surface of the enclosure shroud "cube" (figure 3-6).
Remove the two halves of the shroud.
IN PU
SE
LE
T
CT
CO
A U
M PU
D IO
TE
R
Remove (16)
screws.
Figure 3-6 — Removing the shroud
ce-info@camboard.de
HSA 822M • Maintenance and Modifications
), and cut the
3
HSA 822M
Enclosure
Shroud
3-9
Advertisement
Table of Contents
