Table of Contents
Advertisement
im Vertrieb von
Installation, cont'd
2.
Cable the rear of the AAPs before fastening the AAPs to
the AAP/RJ-45 panel. Route the cables through the hole in
the underside of the surface mount enclosure and connect
them to the rear of the AAPs. If applicable, refer to the
cabling information in the documentation for the AAP.
3.
Insert each of the AAP's screws through the holes in the
AAP opening of the HSA AAP/RJ-45 panel. Secure each
AAP to the panel with the provided captive washers and
#4-40 nuts (figure 2-5).
AAP/RJ-45
Panel
IN P
S E
U T
L E
C T
C O
Figure 2-5 — Mounting an AAP on the AAP/RJ-45
panel
Replace the AAP/RJ-45 panel in the surface mount
4.
enclosure and secure it in place with the screws removed
in step 1. If you lose an AAP/RJ-45 panel screw, four
spare screws are stored in the underside of the enclosure
(figure 2-8 on page 2-11, item
www.camboard.de
2-8
HSA 822M • Installation
#4-40 Nut w/ Captive
Washer
Cable
H S
A 8
2 2 M
A U
M P
U T
D IO
E R
RGB 580xi SI AAP
).
5
CAMBOARD Electronics
Routing the AAP Cables and
Installing the Clamshell
Tel. 07131 911201
Fax 07131 911203
The AAP cables must have freedom of movement to permit
opening and closing the surface mount enclosure. At the same
time, they need to be restrained to prevent them from rubbing
against the edges of the enclosure cable access hole in the
underside of the surface mount enclosure. Rubbing against the
cable access hole edges can damage the cables. Route and
secure the AAP cables as follows:
1.
Manually open the top panel to extend the AAP cables to
their maximum pull.
2.
To prevent wear and tear or movement binding caused by
cable movement, secure the AAP cables inside the
enclosure. Use tie wraps to secure the cables to the tie-
downs accessible through the cable access holes
(figure 2-6).
Figure 2-6 — Cable tie-downs inside the HSA
(seen from underneath)
ce-info@camboard.de
HSA 822M • Installation
2-9
Advertisement
Table of Contents
