Connection Diagrams And System Interface; Preliminary Operations; Single Pump Analog And Digital I/Os Configuration - gefran ADP200 User Manual

Vector inverter for hybrid injection molding machines, pressure/flow control for hybrid injection molding machines

Hide thumbs Also See for ADP200:

Table of Contents

3 Connection diagrams and system interface

Following operations must be done according to ADP200 Quick Start-Up Guide:

Drive power connection (AC mains)

Motor and encoder connection

Basic motor startup

Note!

If motor is already mechanically connected to gear pump, check motor direction of rotation and operate at limited speed

in order to avoid irreversible damage to gear pump itself. Correct motor direction of rotation can be detected following procedure at

section 4.2.3.

The example below shows a typical configuration of the digital inputs and outputs of the drive ADP200, in the

basic configuration. Digital input signals can be set as shown in the typical startup procedure(see figure below):

For special Resolver/Encoder configuration, see ADP200 – QS manual.

The parameter PID_IMM/CONFIGURATION/ 11014 AutoSetup set in the factory configuration all the Analog

I/O. See "Application Function list of Parameters" for a complete description.

Typical (Factory) I/O terminals (Regulation board + I/O expansion)

ADP200 Application PID-IMM

Figure 7: ADP200 Typical Analog & Digital I/O Connections

User Manual

Pag. 10 of 80

Table of Contents

Show Quick Links

Table of Contents