gefran ADP200 User Manual page 75

Auto SoftScope Setup Reserved
SoftScope Mem En
SoftScope Par Mem En Reserved
Motor Torque
Speed Feedback
Pressure Fbk
Speed Ref Mon Int
Pressure Ref Mon Int
Speed Ref Ext
Pressure Ref Ext
Derivative Fbk
Derivative Fbk Filt
P-Output
D-Output
I-Output
Est Gain (P/Q)
Basic Run State
Control Mode
(*) TORQUE an SPEED is displayed according the pump direction convention. Example is the direction is
negative and motor speed [260*] is negative, the Speed Feedback [12006*] show the same value but
positive.
ADP200 Application PID-IMM
Reserved
Motor torque monitor. (*)
Speed feedback monitor. (*)
Pressure feedback monitor.
Speed reference monitor.
Pressure reference monitor.
Speed reference from external PLC (before Ramps) monitor
Pressure reference from external PLC (before Ramps) monitor
Derivative Fbk
Derivative Fbk Filtered
Proportional feed-back monitor
Derivative feed-back monitor
Integrative feed-back monitor
Estimated Q/P Gain
Basic run state (ON (1), OFF (0) )
Actual Control Mode
0 = Pressure
1= Speed/Flow
User Manual Pag. 75 of 80