Table of Contents
Advertisement
Installation
ONLY If You Are Installing HeatShift!
Perform the following steps and see "Appendix D—
HeatShift System" on page 67 for more details
regarding HeatShift planning and installation.
Remove Convection Baffl es
To be eff ective, the HeatShift system requires that two
internal convection baffl es located above the fi rebox
inside the appliance case be removed to allow the hot
air fl ow to
convect upwards into ducts installed on the
fi replace.
Remove the fi rst convection baffl e from the appliance.
It is held in place by 3 screws located right behind the
upper edge of the fi replace opening. Recycle this panel
as it is no longer needed.
Repeat this procedure on the reverse side of the
Appliance front panel—shown transparent for clarity
C o
n v e
c t i o
n b
a ffl
e
Remove convection baffl es
WARNING
The Linear fireplaces requires the
removal of both internal convection
baffles for the HeatShift system to
function properly—read instructions
carefully!
C o
n v e
c t i o
n b
a ffl
e
HeatShift™ System—if used
appliance.
Install HeatShift Take-Off Collars to Appliance
1. Remove the four cover plates on top of the appli-
ance case (6 screws each).
2. Install the collars on the holes on top of the appli-
ance's case (6 screws each).
WARNING
A l l F O U R ( 4 ) t a k e o f f s M U S T B E
C O N N E C T E D T O P L E N U M ( S ) .
29
Advertisement
Table of Contents
