Receiving The Ec-30C; Product Label And Serial Number - M&C EC-30C Instruction Manual

6

Receiving the EC-30C

Heavy device!
Risk of injury when handling heavy equipment.
CAUTION
Do not lift, move or carry the device without help. A second person is
required to lift, move or carry the device.
The cooler should always be transported and stored in an upright
position, with the equipment feet facing downwards to ensure that
the oil in the closed compressor circuit cannot run out of the com-
Note
pressor case.
If the device is transported on its back, it needs to be standing in an
upright position for at least 2 hours before turning on.
The ultra-low cooler EC-30C is a complete pre-installed unit.
Please remove the cooler carefully from the packaging. Check the scope of the delivery
specified on the delivery note. Please make sure that you have received all items stated on
the delivery note.
Please check the unit for any transport damages after receipt and report any complaints to
the transport company immediately.
For transport reasons, the heat exchangers are not mounted inside of the cooler. They are
included in the packaging, but wrapped separately. Connect the heat exchangers proper-
ly before commissioning.
Follow the instructions to connect the tubing to the heat exchangers
Note
on page 40 chapter '8 Installation instructions and mounting of the
EC-30C'

6.1 Product label and serial number

There are two product labels on the EC-30C. One of them is located on the right side of the
cooler and the second one is inside the cooler housing on the bottom plate. Please refer
to this serial number if you have any questions about the device or if you need to order
spare parts or consumables.
The EC-30C features two serial numbers. One serial number is for the
Note
device and the other one for the display controller.
17
EC-30C | 1.00.02 +49 2102 935 888 www.mc-techgroup.com