Commands - DITEC Entrematic HomeLink E2H Installation Manual

5.

COMMANDS

Command
1 5 N.O. STEP BY STEP
OPENING
1 6 N.C. SAFETY STOP
1 6 N.O. CLOSING
1 8 N.C. REVERSAL SAFETY
CONTACT
1 9 N.C. STOP
1 9 N.O. HOLD TO RUN FUNCTION Selecting
1 20 N.O. PARTIAL OPENING
1 20 N.C. AUTOMATIC CLOSING
WARNING: Make a jumper on all NC contacts if not in use. The terminals with the same number are
equal
Function
Selecting
activates a closing or opening operation in the sequence:
open-stop-close-open.
Warning: if automatic closing is enabled, the duration of
the stop is selected via the selection
Selecting
activates an opening operation.
Selecting
contact stops and prevents any movement.
Note: to set the different contact safety functions, see the
Selecting
activates a closing operation.
The opening of the safety contact triggers a reversal of
motion (re-opening) during a closing operation.
Selecting
the opening of the contact prevents any operation.
Selecting
the opening of the contact prevents the closing operation
only.
Opening the safety contact stops the current operation.
Note: the ashing light ashes.
permanent opening of the safety contact enables the hold
to run function.
In this state, the opening (1-5) and closing (1-6) controls
function only if held in the pressed position, and the auto-
mation stops when the controls are released.
Any safety devices, plus the automatic closing, are disa-
bled.
Selecting
activates a partial opening operation of the door wing
adjustment
Warning: if automatic closing is enabled, the duration of
the stop is selected via the adjustment
Selecting
the contact enables automatic closing.
6
Description
, the closure of the contact
, the closure of the contact
, the opening of the safety
parameter settings.
, the closure of the contact
,
,
and
, the closure of the contact
.
, the permanent closure of
.
with the automation idle,
with the automation idle,
, the
.