PROFACE PL-B910 Series User Manual page 71

System Setup
! MODEM Use IRQ
Selections for this feature include [NA],[3],[4],[5],[7],[9][10], and [11].
The [NA] selection is factory set and recommended for most users.
! HDD Power Down
Designates the length of time until the motor of the hard disk stops. The
available selections are[1Min]
factory set and recommended for most users.
! Doze Mode
When there is no reply from the system within designated time, by using
this mode the CPU operation will be automatically stopped. [Disable] is
factory set and recommended for most users.
! Suspend Mode
When there is no reply from the system within designated time, by using
this mode all peripheral equipment operation will be stopped. [Disable]
is factory set and recommended for most users.
! VGA
Designates if the system is turned on when any event is driven in the
VGA port. The available selections are [ON] and [OFF]. [OFF] is factory
set and recommended for most users.
! LPT & COM
Designates if the system is turned on when any event is driven in the
serial port or the printerport. The available selections are [None], [LPT],
[COM] and [LPT /COM]. [LPT/COM] is factory set and recommended
for most users.
! HDD & FDD
Designates if the system is turned on when any event is driven in the
hard disk or floppy disk. The available selections are [ON] and [OFF].
[ON] is factory set and recommended for most users.
DMA / master
!
Designates if the system is turned on when any event is driven in the
DMA controller. The available selections are [ON] and [OFF]. [OFF] is
factory set and recommended for most users.
! Primary INTR
Designates if the system is turned on when any event is driven in the
Primary Interrupt Controller. The available selections are [ON] and
[OFF]. [ON] is factory set and recommended for most users.
! IRQ3-IRQ15
Designates if the COM Port is monitored or not. The available selections
are [Disabled], [Primary] and [Secondary].
PL B900/B910 Series Users Manual
[15Min] and [Disabled]. [10Min] is
%
5-9