Table of Contents
Advertisement
5.2
System Parameters
Use the menu screen to select a System Item, and then enter the desired system
information. Each item's detailed settings are shown here.
Normally, use only the factory (default) settings.
5.2.1 STANDARD CMOS SETUP
Selecting the STANDARD CMOS SETUP menu item produces the following
screen.
Date (mm:dd:yy): Thu,Jul 2 2000
Time (hh:mm:ss): 14 : 50 : 3
Drive C
Drive D
Drive A
Video :
VGA Text Mode :
VGA Graphics Mode : Normal
Halt On :
ESC
F1
! Date/Time
This data sets the PL's internal time and date.
Hours
Minutes
Seconds
! Drive C
This data sets the IDE hard disk's parameters. When this setting is set to
[AUTO], the hard disk's parameters are automatically read in. Also, if the
"IDE HDD AUTO DETECTION" is in use, the value entered there is
automatically set. The three options are [User],[Auto], and [None]. The
[Auto] setting is factory set and recommended for most users.
! Drive D
The three options are [User],[None]and [Auto].
! Drive A
This setting determines the format used by the PL's internal floppy disk
drive. The[1.44M - 3.5in] selection is factory set and recommended for
most users. The other available settings are [720K - 3.5in], [1.2M -
5.25in], [360K - 5.25in], [2.88M - 3.5in.], and [None].
5-2
ROM PCI/ISA BIOS(2A5LEU1C)
STANDARD CMOS SETUP
AWARD SOFTWARE, INC.
CYLS.
:Auto(
0Mb) 0
:Auto(
0Mb) 0
:1.44M,3.5 in.
EGA/VGA
Normal
All, But Disk/Key
:
Quit
# $ % &
:
Help
(Shift)F2
:00 - 23
:00 - 59
:00 - 59
HEADS
PRECOMP LANDZONE SECT0RS MODE
0
0
0
0
0
0
Base Memory
Extended Memory
Other Memory
Total Memory
:
Select
Item
PU/PD/+/-
:
Change Color
* The above settings are factory settings.
PL B900/B910 Series Users Manual
System Setup
0
AUTO
0
AUTO
:
640K
: 645612K
:
384K
:
66536K
:
Modify
Advertisement
Table of Contents
