Connecting An Analog Rgb Monitor - PROFACE PL-B910 Series User Manual

3.1.10 Connecting an Analog RGB Monitor

The following explantion connects the PL to a commercially available CRT
monitor, or to the Flat Panel (FP) display.
! ! ! ! ! Connecting a CRT Monitor
When connecting the CRT monitor, be sure that it is a standard analog multiscan
VGA compliant type.
! ! ! ! ! Connecting the FP-570
Digital's FP-570 monitor can also be connected the the PL unit. For conenction
details,
When the FP is connected to a PL-B910/PL-B911 (PL-B910 series) unit,
the touch panel cannot be used, only the display.
When the FP is used, the user's system or OS must me set up first.
Please perform the following steps.
1) Connect a standard CRT monitor.
2) Perform the specified system setup
3) Set up the OS
4) Designate the Display (Output) device.
This is performed via the Control Panel's [Screen] settings. Open the [Screen
Properties] dialog box and designate the display device as CRT.
If the incorrect display (output) device is designated, simply press the
[ESC] key and cancel the settings. If cancelling is not possible, contact
your local PL distributor for assistance.
5) Shut down the OS.
6) Connect the FP-570.
7) Restart the OS.
PL B900/B910 Series Users Manual
Analog RGB
c o n n e c t o r
cover
Analog RGB
connector
CRT Monitor
FP-570 Series User Manual.
1) Unscrew the Analog connector
cover's attachment screw, and re-
move the cover.
2) Connect the CRT monitor's cable to
the PL's analog RGB connector.
PL Front Face
Chapter 5 - System Setup
Chapter 6 - Setting Up Your PL OS
3-13