Table of Contents
Advertisement
Chapter
3
A wide variety of optional units and expansion boards made by Digital can be
installed in the PL, as well as a number of commercially available PCI-bus or ISA-
bus compatible boards. This chapter describes how to install these products in the PL.
3.1
Installation
The following explanation pages describe the installation procedures for the PL's
DIM module (PL-EM220/PL-EM230), FDD unit (PL-FD200/PL-FD210), HDD
unit (PL-HD2*0), expansion boards, CD-ROM drive unit (PL-DK200), Display
Expansion Board (PL-PE200), Special Display (PL-DU6900/PL-DU7900) and the
PL's cooling fan.
For information about the installation of other option units, please refer to those
unit's individual [Operation Instructions].
To avoid electric hazards, be sure to turn the PL's power OFF
before installing any optional units or expansion boards.
• Use a screwdriver to loosen or tighten the screws. Be careful not to
tighten screws to tightly, since it may damage the equipment.
• Be careful when removing or inserting any screws that they do not
fall inside the PL.
PL B900/B910 Series Users Manual
Installing Optional Units
and Expansion Boards
WARNING
1. Installation
3-1
Advertisement
Table of Contents
