Table of Contents
Advertisement
K
L
P
Q
R
S
PL-B900 Right Face
K
V
L
T
S
P
Q
R
PL-B910 Right Face
U
PL B900/B910 Series Users Manual
K: Keyboard Connector
M
L: Mouse Connector
M:Expansion Slots
N: Side Mount FDD Slot
O:HDD/FDD Expansion Slot
P: Power LED
N
O
Q:Power LED Output Connector
M
R: Hardware Reset Switch
S: Standard Display Connector
T: Standard USB Connector (USB)
N
O
U: Dip Switches (SEL.)
V: Expansion Display Connector
A PS/2 compatible keyboard can be connected here.
A PS/2 compatible mouse can be connected here.
Slots for PCI/ISA Bus compatible expansion
boards.
Houses the FDD (PL-FD200) unit.
Houses either the FFD or the HDD unit.
This LED indicates both the RAS monitor
feature's status and the PL's power status. An
RAS alarm will cause this lamp to blink.
Appendix 2 RAS Feature
Used when installing the PL in the optional 19"
mount to provide power LED output.
Pushing this switch resets the PL.
Used to connect Digital's Standard Display
Cable. (PL-CB200-*M)
This interface is USB 1.0 compliant. Compatible
USB devices can be connected here. (PL-B910/
PL-B911)
Use the factory settings. (PL-B910/PL-B911 only)
OFF ON OFF ON
Factory Settings
Be sure to set the DU unit's dip switches to the
same setting as the PL.
PL-X900 Series Standard Display
PL-DU6900/PL-DU7900 Users Manual.
When using 2 DU units, Digital's display cable must
be used (PL-CB200-5M). This cable connects to the
PL's Display Expansion Board (PL-PE200). The
picture used here shows the Display Expansion
Board installed. (PL-BP10/PL-B911 only)
(GVIF OUT)
2-10
Advertisement
Table of Contents
