Table of Contents
Advertisement
2. Refasten the inner SCSI bracket screws in their original locations inside the Media
3. Connect the low profile right-angle SCSI connector on the NTRH3502 cable to the
4. Fasten the SCSI cable drain wire to one of the screws that previously held the inner
5. Replace the inside front cover plate.
6. Replace the front bezel.
®
Avaya CallPilot
201i Server Hardware Installation
Gateway or Media Gateway Expansion.
You will use one of the screws later to fasten the NTRH3502 SCSI cable drain wire.
SCSI connector on the 201i server faceplate.
SCSI bracket in place.
Notes:
• Use the screw that is the most convenient.
• Press firmly on the drain wire Y-connector until it snaps into place around the
screw post.
For instructions, see
To replace the inside front cover plate
Important:
Ensure that the tabs on the bottom and right side of the inside front cover plate
are positioned inside the Media Gateway or Media Gateway Expansion.
Before you begin
on page 88.
December 2010
87
Advertisement
Table of Contents
