Table of Contents
Advertisement
Installing the SCSI cables for Meridian 1
Introduction
Before you can connect a CD-ROM or tape drive to the 201i server, you must install the SCSI
cables. The SCSI cables route the SCSI connection away from the 201i server faceplate so
that an external SCSI device can remain permanently connected.
Caution:
Risk of equipment damage
You must power off the 201i server before connecting or disconnecting SCSI cables.
Cables you need
You require the following cables:
• NTRH1408 (for connecting the 201i server to the Meridian 1 I/O panel)
The connector on the intermediate SCSI cable that attaches to the 201i server faceplate is
a low-profile right-angle connector. This allows the cable to be attached with the Meridian
1 cabinet cover on.
®
Avaya CallPilot
201i Server Hardware Installation
Installing the SCSI cables for Meridian 1
December 2010
51
Advertisement
Table of Contents
