Table of Contents
Advertisement
3. Connect one end of the RJ-11 phone cord to the line jack on the modem and the
4. Plug the power cord into an electrical outlet with an isolated ground.
5. Plug the other end of the power cord into the modem power connector.
6. Power on the modem.
7. Place the modem in an area where it cannot be accidentally damaged or where
®
Avaya CallPilot
201i Server Hardware Installation
c. Connect the 9-pin female connector to the RS-232 COM1 connector on
the multi I/O cable and tighten the nuts.
other end to an analog jack.
Caution:
Risk of equipment damage
Connect the modem to an analog line only. The use of a non-analog line (for
example, digital or Multiline) can damage the modem.
Result: The back of the modem appears similar to the following:
Note:
Ensure that the modem is receiving power by checking that at least one LED
on its front panel is lit.
people cannot trip over attached cords.
Required equipment
December 2010
125
Advertisement
Table of Contents
