Table of Contents
Advertisement
3. Connect the low-profile right-angle SCSI cable connector to the SCSI connector on
4. Connect an additional device in a daisy chain, if required, using either the SCSI
5. Connect the power cord for each device.
6. Power up the devices.
7. Continue with
®
Avaya CallPilot
201i Server Hardware Installation
To connect the CD-ROM and tape drives to the 201i server (Meridian 1)
IF the first device is the
tape drive
the 201i server faceplate.
cable supplied with the device or an NTRH3502 cable.
The following diagram shows cable connections, where the CD-ROM drive is the
first device:
Note:
Alternate SCSI device connection scenarios are supported, but are not depicted
in this guide. If you want to use a connection scenario that is not described in this
guide, ensure that you use appropriate cabling for each SCSI device.
What is next?
THEN
b. Connect the NTRH3502 SCSI cable that you
installed earlier on the Option 11C Mini to the
SCSI adapter on the CD-ROM drive.
connect the NTRH3502 SCSI cable that you
installed earlier on the Option 11C Mini to the
tape drive.
on page 121.
December 2010
119
Advertisement
Table of Contents
