Table of Contents
Advertisement
Connecting peripheral devices to the 201i server
3. Connect the low-profile right-angle SCSI cable connector to the SCSI connector on
4. Connect an additional device in a daisy chain, if required, using either the SCSI
5. Connect the power cord for each device.
6. Power up the devices.
7. Continue with
To connect the CD-ROM and tape drives to the 201i server (Option 11C Mini)
1. Connect the first SCSI device.
2. Follow instructions below.
®
118
Avaya CallPilot
the 201i server faceplate.
cable supplied with the device or an NTRH3502 cable.
The following diagram shows cable connections, where the CD-ROM drive is the
first device:
Note:
Alternate SCSI device connection scenarios are supported, but are not depicted
in this guide. If you want to use a connection scenario that is not described in this
guide, ensure that you use appropriate cabling for each SCSI device.
What is next?
IF the first device is the
CD-ROM drive
201i Server Hardware Installation
on page 121.
THEN
do the following:
a. Attach the A0769312 SCSI adapter to the
CD-ROM drive.
December 2010
Advertisement
Table of Contents
