Table of Contents
Advertisement
5. Connect the power cord for each device.
6. Power up the devices.
7. Continue with
To connect the CD-ROM and tape drives to the 201i server (Option 11C)
1. Connect the first SCSI device.
2. Follow instructions below:
®
Avaya CallPilot
201i Server Hardware Installation
To connect the CD-ROM and tape drives to the 201i server (Meridian 1)
Note:
Alternate SCSI device connection scenarios are supported, but are not depicted
in this guide. If you want to use a connection scenario that is not described in this
guide, ensure that you use appropriate cabling for each SCSI device.
What is next?
IF the first device is the
CD-ROM drive
tape drive
on page 121.
THEN
connect the NTRH3502 SCSI cable from the
CD-ROM drive to the SCSI connector that is
located on the intermediate SCSI cable bracket
assembly (NTRH1407) on the Option 11C.
do the following:
a. Attach the A0769312 SCSI adapter to the
tape drive.
b. Connect the NTRH3502 SCSI cable from the
adapter to the SCSI connector that is located on
the intermediate SCSI cable bracket assembly
(NTRH1407) on the Option 11C.
December 2010
117
Advertisement
Table of Contents
