Table of Contents
Advertisement
Connecting peripheral devices to the 201i server
To connect the CD-ROM and tape drives to the 201i server (Communication
Server 1000)
1. Connect the first SCSI device.
2. Follow instructions below:
3. Connect an additional device in a daisy chain if required, using either the SCSI cable
®
120
Avaya CallPilot
IF the first device is the
CD-ROM drive
tape drive
supplied with the device or an NTRH3502 cable.
The following diagram shows cable connections, where the CD-ROM drive is the
first device:
Note:
Alternate SCSI device connection scenarios are supported, but are not depicted
in this guide. If you want to use a connection scenario that is not described in this
guide, ensure that you use appropriate cabling for each SCSI device.
201i Server Hardware Installation
THEN
do the following:
a. Attach the A0769312 SCSI adapter to the
CD-ROM drive.
b. Connect the NTRH3502 SCSI cable that you
installed earlier on the Option 11C Mini to the
SCSI adapter on the CD-ROM drive.
connect the NTRH3502 SCSI cable that you
installed earlier on the Option 11C Mini to the
tape drive.
December 2010
Advertisement
Table of Contents
