Power Connection - Christie RPMX-D120U Setup Manual

2.6 Power
Connection
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
020-100038-02 Rev. 1 (09/08)
Do not attempt operation if the AC supply and cord are
not within the specified voltage and power range.
The North American rated line cord is provided with this
projector. For all other regions, ensure that you are
using a line cord, power plug and socket that meet the
Do not use a line cord that has been damaged.
When connecting the projector to AC: Plug an appropriately rate line cord
to the AC receptacle located on the electronics module and the 3-pronged end
into a grounded AC outlet. Note: The outlet must be near the equipment and
easily accessible. Use only the line cord provided with the projector or a power
cord of appropriate ratings that comply with regional standards. The input
voltage to the projector must be capable of 100-240 VAC.
When disconnecting the projector from AC: Power down the projector
and wait for the internal cooling fans to stop before turning the main power
switch on the electronics module OFF. This gives the lamps enough time to cool.
At that time, unplug the line cord from the wall outlet.
Refer to Section 6 – Specifications for complete details on all power requirements
for the projector.
Wait for the cooling fans to stop before turning the main
power switch OFF and unplugging the projector.
WARNINGS
appropriate rating standards.
WARNINGS
Section 2: Installation & Setup
2-21