Components - Christie RPMX-D120U Setup Manual

Section 1: Introduction
How the projector works
1.2

Components

1-2
Key features (
See Section 6 for a complete list of product specifications.
•
RPMSP – Native SXGA+, 1400 x 1050 resolution
•
RPMX – XGA, 1024 x 768 resolution
•
24-bit RGB display
•
10-bit image processing module
•
Display of RGB, NTSC, PAL, and SECAM video inputs and HDTV formats
•
User adjustable lamp power
•
Mechanical lamp changer for easy lamp change during operation
•
Picture-in-picture display
•
Automatic calibration of display color settings
•
Edge Blending ability via software for seamless displays
•
Dual frequency IR sensor for use with standard IR remote and optional
long-range dual frequency remote
•
Unique 6-axis image geometry adjustment mechanism
•
Memory for up to 50 custom "channels" (source setups)
•
Intuitive on-screen menu system
•
Built-in GPIO port to enable active control of external devices
•
LED display for projector status monitoring
•
Multiple control options including RS-232 and RS-422
•
On-board ChristieNET™ software
•
Universal AC input 100-240 VAC, 50/60Hz
The user selects which lamp will be in operation through the Lamp Menu; Lamp
#1 or Lamp #2. After the lamp successfully ignites, the light generated is
sequentially filtered into the RGB color primaries by the spinning color wheel in
the light engine of the projector. This filtered light is then presented to the single
chip DMD, located in the light engine. The reflected light from the DMD chip
then passes through the projection lens to the screen to display the image.
Ensure you have received the following components before using your projector.
Line Cord
(rated, North American)
Configuration bracket
Set of positioning tubes
enclosure)
6, M6 screws
*User's Kit, which includes the following:
User's Manual
IR Remote Keypad
Setup and Adjustment Tools
ball driver, nylon spacers, lint free gloves)
*NOTE: A User's Kit is provided with each projection system. Additional
User's Kits can be purchased separately (part number 102-138101-01).
Additional Tools Required
In addition to the contents of the user kit, it is recommended the following tools
be kept on hand during installation and setup:
#1 Phillips screwdriver
Level
(shipped loose, for horizontal configuration)
(required when installing projector into CC50/CC67 cube
(for installation of configuration bracket)
---- ----
(with batteries)
(includes 2mm and 5mm ball drivers, 8mm hex
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
):
----
020-100038-02 Rev. 1 (09/08)