Christie RPMX-D120U Setup Manual page 19

Step 8
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
020-100038-02 Rev. 1 (09/08)
Adjust software to optimize image
Use the following as a guide to optimally adjust your projector through various
software settings for the first time.
NOTES: 1) Refer to Section 3 for details on accessing and adjusting individual
settings. 2) Unless otherwise indicated, instructions apply to all projector models in
stand-alone or multi-projector configurations.
1. Display an external signal.
2. Select a lamp operation mode. Perform all setups in the mode you select.
3. Assign projector ID number(s).
4. Select Image Orientation in the Configuration menu and change the
orientation of the displayed image to suit the installation. For example, in
rear screen displays, select "rear" to display the image correctly.
5. Modify options in Menu Preference to suit your display preferences. For
example, select Language to change the menu language to any of the
five available languages.
6. Enable Broadcast Key in the Communications menu – this enables you
to switch between communicating with one or all projectors.
7. Select Auto Setup to give the projector a change to setup the best
possible settings for the chosen incoming signal.
8. Verify that Processing Mode, in Image Settings, is correct for the
selected source.
9. Change Resize Presets if you want the image displayed at any other
resolution other than native.
10. Adjust Pixel Phase and Pixel Tracking from the Size and Position
menu to eliminate any noise from the displayed image.
11. Adjust H-Position and V-Position from the Size and Position menu to
re-center the image on screen.
12. Adjust Size in Size and Position until the image is at the desired width
then adjust Vertical Stretch. Adjusting one option may have an affect on
the other, repeat adjustment if necessary. Adjust H-Position and V-
Position again if required to center the image.
13. Adjust Color Wheel Delay.
14. Perform Color Temperature setup.
15. Adjust blacklevels and input levels.
16. Adjust lamp power to match lamp brightness of adjacent projectors, if
necessary.
17. Adjust color primaries, brightness uniformity and edge blending using
the detailed procedure provided in Section 3 – Matching Colors in
Multiple Projectors.
Section 2: Installation & Setup
2-11