Christie RPMX-D120U Setup Manual page 21

YPbPr signals
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
020-100038-02 Rev. 1 (09/08)
NOTES: 1) If for some reason the projector fails to recognize a signal as an
RGB signal, specify the Color Space option within the Image Settings menu. See
3.7, Adjusting the Image. 2) To connect YPbPr signals–such as from DVDs or
analog HDTV sources–to
YPbPr Signals (below). 3) Use the computer cable provided, to connect some devices
to the DVI-I connector at Input 2.
Connect a YPbPr signal (component video) to
or as shown in .
INPUT 1 INPUT 2
NOTES: 1) If, for some reason, the projector
fails to recognize a YPbPr signal, specify the
Color Space option within the Image Settings
menu. See 3.7, Adjusting the Image. 2) Do
not connect digital component signals (known
as YCbCr) to . Install an appropriate
INPUT 1
optional module in
INPUT 5
, use the red, green and blue BNCs as described in
INPUT 1
for this.
Section 2: Installation & Setup
Figure 2.14. Connecting
YPbPr
2-13