Christie RPMX-D120U Setup Manual page 34

Section 3: Operation
3-4
Table 3.1. Auto Setup
OPTIMIZES:
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
NOTE: You must have an unlocked channel present to use Auto Setup.
Channel
Channel
Press to select a specific source setup (channel) defined and stored in
Channel
projector memory. Once you enter a 2-digit channel number (or, if there is a list
displayed, highlight it and press
update according to the numerous setup parameters defined for that channel.
Note that a new channel is automatically created if you adjust an image from a
new source.
NOTE: Channel (
or not the Display Channel List option is enabled in the Menu Preferences
menu. You can choose to use a scrollable list of channels when you press
you may prefer to enter the desired channel number "blind", i.e., without on-
screen feedback. See Menu Preferences later in this section.
Input 1
Input 1
Press to display from the data or video input source connected to BNCs
Input 1
labeled .
INPUT 1
Input 2
Input 2
Press to display from the DVI source connected to
Input 2
Input 3
Input 3
Press to display from the composite video source connected to
Input 3
Input 4
Input 4
Press to display from the S-video source connected to
Input 4
Input 5
Input 5
Press to display from the
Input 5
slot.
NOTE: If you have the new optional Dual SD/HD-SDI Module installed at
you can connect two inputs – A and B. Whether you are displaying from
INPUT 5
or from another input, press
INPUT 5
again to toggle to the other input.
Input 5
Input 6
Input 6
NOTE: Not applicable.
What an "Auto Setup" Does
), the display will automatically change and
) key behavior during a presentation depends on whether
Channel
interface module installed in the Option 1
INPUT 5
to display the input last used. Press
Input 5
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
SETS TO DEFAULT:
Contrast
Brightness
Auto Input Level (off)
Detail
(if video source)
Filter
Luma Delay
.
INPUT 2
.
INPUT 4
020-100038-02 Rev. 1 (09/08)
, or
Channel
.
INPUT 3