Christie RPMX-D120U Setup Manual page 42

Section 4: Maintenance
Projector Location
Lamps
Power Cord
and Attachments
4-2
Operate the projector in an environment, which meets the operating range as
specified in Section 6 – Specifications.
◊
Do not operate the projector close to water, such as near a swimming pool.
Do not operate in extremely humid environments.
◊
Do not place the projector on an unstable cart, stand or table. A projector and
cart combination should be used with care. Sudden stops, excessive force and
uneven surfaces may cause the projector and cart combination to overturn.
◊
Do not ceiling mount this projector.
The 2 100/120W UHP lamps for the RPMX/RPMSP-D120U and the 275W UHP
lamps for the RPMSP-D275U require replacement when they have reached their
end of life (approximately 10000 hours for RPMX/RPMSP-D120U models and
2250 hours for RPMSP-D275U models), if they have failed during operation, or
have a drastic change in brightness (typical of aging lamps). To effectively
maintain operation of the projector it is best to be aware of any changes that
occur in brightness and the number of hours each lamp is in use. Refer to 4.4.
Lamp Replacement for more details on lamp replacement.
Follow all safety and warning precautions regarding lamp replacement and
handling.
Wait approximately 5 minutes to allow the lamp to
HOT
Do not stick hands into the lamp compartment
The lamp is under great pressure when hot and may
explode causing physical injury and/or property
damage. Allow a lamp to cool before handling and/or
powering down and unplugging the projector.
Use only the lamps supplied by CHRISTIE, in the Lamp
Replacement Kit for these projectors.
Use only the attachments and/or accessories recommended by CHRISTIE. Use of
others may result in the risk of fire, shock or personal injury.
Use only the AC power cord supplied. Do not attempt
operation if the AC supply is not within the specified
voltage and power range. See Section 6.
◊
Do not set or rest items on the power cord. Place the projector in an area
where the projector cord cannot be abused or damaged by persons walking
on it or by objects rolling over it.
◊
Operate the projector at the specified voltage only. Do not overload power
outlets and extension cords as this can result in fire or shock hazards.
WARNING
cool before removing.
during lamp replacement.
WARNING
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
020-100038-02 Rev. 1 (09/08)