Christie RPMX-D120U Setup Manual page 36

Section 3: Operation
3-6
NOTE: Disable PIP and Best Switching for Interlaced sources > 35 kHz.
Function Key
Func
IF WITHIN A MENU:
noted with the appropriate topic elsewhere in Section 3. For example, press
in the Channel Setup menu to enable deletion or copying of a channel.
IF WITHIN A PRESENTATION:
2-digit number to enable a specific color or colors in
the display (see right). For example,
display only red and green data,
display all color data. Eliminating one or more colors
can help with certain diagnostics and setups, such as
when accurately overlaying one image on top of
another from stacked projectors.
NOTE: Color enabling can also be implemented from numerous locations within
the menu system.
Shutter
Shutter
Not applicable.
Projector
Proj
Press Proj to access a specific projector within a group of projectors or to
confirm if the local projector is listening. The number in the "Enter Number"
window indicates which projector is currently listening to commands, and will
match the projector number that has been defined in the Menu Preferences menu.
The "Projector" checkbox (read-only) shows whether or not the projector
physically connected to a keypad is listening to commands from that keypad. A
checkmark means that connected projector is listening; if there is no checkmark,
you are communicating with a different projector.
To control a specific projector with the keypad, enter the 3-digit number assigned
to the projector you want to use. If you switch to a projector other than the one
you are currently using, the checkmark will disappear.
When broadcasting to multiple projectors, press
without entering a projector number. Keypad commands will then affect all
projectors present. There is no method of controlling a group of projectors within
the same wired configuration using the wired keypad exclusively, since there is
only one wired protocol available.
NOTE: The "Broadcast Keys" option in the Communications menu must be
selected for only one (any) projector in a serial network. The keypad in use must
be OFF (disabled) for the remaining projectors. See also 3.6, Adjusting System
Parameters and Advanced Controls.
Enter
Press to select a highlighted item, to toggle a checkbox, or to accept a
parameter adjustment and return to the previous menu or image.
Using the for special tasks within the menu system is
Func
Press followed by a
Func
6
Func
6 7
Func
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
4
will
will
Proj Proj
and then again
020-100038-02 Rev. 1 (09/08)
Func