Biooptix 10 Left-Side Controls And Connections; Biooptix 10 Left-Side Connections; Biooptix 10 Left-Side Connections - Teledyne 10 Installation And Operation Manual

BioOptix™ 10
Section 1 Introduction
1.3.2 BioOptix 10 Left-side
Controls and
Connections
Figure 1-2 BioOptix 10 left-side connections
Item Name
1 Buffer A Inlet Ports
2 Buffer B Inlet Ports
3 Sample In Ports
4 Pump Purge Port
5 Waste Ports
6 Internal Drain
7 Power Switch
1-4
1
2
3
6
Table 1-3 BioOptix 10 Left-side Connections
Description
Ports to accept Buffer A solution for each channel.
Ports to accept Buffer B solution for each channel.
Ports to accept sample for each channel.
When the Mode Knob is in the Purge Pump position, pumped fluids are
diverted to this port, bypassing the column, detection, and collection.
Connects to waste collection container(s). Connecting to separate contain-
ers allows isolation of waste buffers by each channel, which could be benefi-
cial should a purified sample fail to collect.
Fluid from internal leaks exit the case through this opening. Internal leaks
are the result of pump seal failures due to neglected routine maintenance.
I = On
0= Off
4
5
7