Horizontal Control And Vertical Control - ITech IT6412 User Manual

4.3 Horizontal Control and Vertical Control

Adjust horizontal (time/grid) calibration
When the [Knob] soft key is pressed and "T/Div" is selected, horizontal
calibration (scanning speed) can be adjusted by rotating the knob. In this case,
time/grid information changes can be observed on the screen by rotating the
knob and changing the horizontal (time/grid) setting. When acquisition is run,
the sampling rate can be changed by adjusting the horizontal calibration knob.
Adjust trigger delay (position)
When the [Knob] soft key is pressed and "T/Del" is selected, the trigger delay
can be adjusted by rotating the knob. In this case, when the knob is rotated, the
trigger point will move horizontally and the delay time will be displayed on the
screen. When the delay time is changed, the trigger point (
horizontally, and the distance between the trigger point and the horizontal
center will be indicated. The trigger point is displayed along the top of the
display grid.
Adjust vertical calibration
1. On the Waveform Display interface, press the [V_Range] or [I_Range] soft
key to display the following interfaces:
Copyright © Itech Electronic Co., Ltd.
Waveform Display Function
) will move
29