3. How to Install
Select the best possible operation site by considering the following (see details on
the following pages, and the respective Design Guides):
•
•
•
•
3
•
•
•
•
3.2.2. Receiving the Frequency Converter
When receiving the frequency converter please make sure that the packaging is intact, and be
aware of any damage that might have occurred to the unit during transport. In case damage has
occurred, contact immediately the shipping company to claim the damage.
3.2.3. Transportation and Unpacking
Before unpacking the frequency converter it is recommended that it is located as close as possible
to the final installation site.
Remove the cardboard box and handle the frequency converter on the pallet, as long as possible.
Remark: The card box cover contains a drilling master for the mounting holes.
Illustration 3.2: Mounting Template
3.2.4. Lifting
Always lift the frequency converter in the dedicated lifting eyes. Use a bar to avoid bending the
lifting holes of the frequency converter.
16
Ambient operating temperature
Installation method
How to cool the unit
Position of the frequency converter
Cable routing
Ensure the power source supplies the correct voltage and necessary current
Ensure that the motor current rating is within the maximum current from the frequency
converter
If the frequency converter is without built-in fuses, ensure that the external fuses are
rated correctly.
MG.20.P1.02 - VLT
VLT AQUA High Power Operation Instructions
®
is a registered Danfoss trademark