Danfoss VLT AQUA High Power Operating Instructions Manual page 97

VLT AQUA High Power Operation Instructions
4.2. Parameter Options
4.2.1. Default settings
Changes during operation
"TRUE" means that the parameter can be changed while the frequency converter is in operation
and "FALSE" means that the frequency converter must be stopped before a change can be made.
4-Set-up
'All set-up': the parameter can be set individually in each of the four set-ups, i. e. one single
parameter can have four different data values.
'1 set-up': data value will be the same in all set-ups.
Conversion index
This number refers to a conversion figure used when writing or reading by means of a frequency
converter.
Conv. index
Conv. factor
Data type
2
3
4
5
6
7
9
33
35
54
SR = Size related
NB!
When you carry out manual initialisation, you also reset serial communication, RFI
filter settings (par. 14-50) and fault log settings.
Removes parameters selected in
NB!
After initialization and power cycling, the display will not show any information until
after a couple of minutes.
100 67 6 5 4
1 1/60 100000 100000 10000 1000
0
Description
Integer 8
Integer 16
Integer 32
Unsigned 8
Unsigned 16
Unsigned 32
Visible String
Normalized value 2 bytes
Bit sequence of 16 boolean variables
Time difference w/o date
®
MG.20.P1.02 - VLT is a registered Danfoss trademark
4. How to programme the frequency converter
Personal Menu
.
3 2 1 0 -1 -2
100 10 1 0.1 0.01
-3 -4 -5 -6
0.00 0.000 0.0000 0.000001
1 1 1
Type
Int8
Int16
Int32
Uint8
Uint16
Uint32
VisStr
N2
V2
TimD
4
97