Internal Buzzer; Access Codes - Honeywell NOTIFIER ID61 Operating Manual

FIRE
DISABLEMENT
TEST POWER SUPPLY FAULT
DELAYS ACTIVE EARTH FAULT
FIRE OUTPUT: FAULT / DISABLED SYSTEM FAULT
FIRE OUTPUT ACTIVE
SOUNDER: FAULT / DISABLED
PLANT ALARM PRE- ALARM
POWER
FIRE CONTROL O/P: FAULT / DISABLED
Operations within this
manual require Level 2
access (code or keyswitch),
although a Level 3 access
code may be entered.
Throughout this manual a
'U' accompanied by a
number represents a
Level 2 access.
ID61/62 Series Panel - Operating Manual

4.1.2 Internal Buzzer

The panel has an internal buzzer which gives a local
warning when any of the following is detected:
FAULT
a. Fire condition.
b. Pre-alarm condition.
c. Fault condition.

4.1.3 Access Codes

With the exception of the Loop Booster Output Test option,
the actions described in this manual require access Level 2,
which is invoked either by turning the keyswitch or by entry
of an access code. The access code is a sequence of
numbers configured in the panel during commissioning. The
panel has two levels of access codes, Level 2 and Level 3.
Level 3 is required for testing the loop booster output and
for panel configuration and commissioning procedures.
The panel has a maximum of ten (10) Level 2 access
codes, each defined by the user identification number
[U0 - U9] in the top left-hand corner. Entering a Level 2
access code allows access to all functional controls and
some system operation parameters. (Operating the
keyswitch to enter Level 2 always displays '[U9]').
Note: When the panel is at Level 3, [S1] is displayed in
1 Press the '
ACCESS TO MENUS RESTRICTED
Enter Level 2/3 Passcode: . . . .
5
2 Press and hold the '
ACCESS TO MENUS RESTRICTED
Enter Level 2/3 Passcode: * * * *
3 Press the '
[U0] 1:Test
4 The procedure to cancel Level 2 (and thus prevent
Note: If an incorrect access code is entered, the following
ERROR - INCORRECT PASSCODE ! ! !
place of the user identification number.
' button at the 'Status: NORMAL'
message to prompt for a Level 2/3 access code, as
shown below:
0..9
appropriate 4 digit Level 2 access code. '*' will appear
on the LCD as the numbers are entered.
' button to confirm the entered code.
5
The Level 2 Options are then displayed.
2:Disable/Enable
4:View Mode
any other person accessing Level 2 options) is given
in Section 4.1.1).
is displayed:
Press the ' ' button or wait for approximately one
4
minute to return the 'Status: NORMAL' message.
13
< : BackSp
' button while pressing the
< : BackSp
3:Clock
5:Commission
997-458-000-8, Issue 8
January 2010