Replace The Rtm Ip 4000 Card - Polycom RealPresence RMX 4000 Hardware Manual

RealPresence Collaboration Server (RMX) 4000 Components and Components Replacement

Replace the RTM IP 4000 Card

Note: RTM IP 4000 connections to MPMx/MPMRx card
RTM IP 4000 connections require Ferrite cables when connecting to MPMx/MPMRx cards.
The RTM IP 4000 card on the rear of the RMX 4000 provides connectivity to all the MCU modules. Use the
following procedure to replace the RTM IP 4000 card.
To replace the RTM IP 4000 card:
1 Ensure that the power switch/circuit switch on the RMX 4000 is turned OFF (O).
2 Remove the cables connected to the card.
3 Unscrew the captive screws on the rear panel of the RMX 4000 that secure the
RTM IP 4000 card.
4 Use the metal ejector levers to pull the RTM IP 4000 card out of its slot in the backplane.
5 Carefully slide the RTM IP 4000 card out through the rear panel.
6 On the card to be installed, move the ejector levers to their fully open position.
7 Slide in the replacement RTM IP 4000 card.
8 Push the RTM IP 4000 card firmly into the backplane, making sure it is properly seated in its slots.
9 Ensure that the metal ejector levers are fully retracted into their housings.
10 Tighten the captive screws on the rear panel of the RMX 4000 that secure the
RTM IP 4000 card.
11 Reconnect the cables.
12 Turn ON the RMX 4000.
Polycom, Inc. 75