Changing The Polarity Of The Remote Outputs From Chromquest - Thermo Scientific Surveyor PDA Plus Hardware Manual

Changing the Polarity of the Remote Outputs from ChromQuest

Thermo Scientific
Figure 17. Configuration page of the PDA Direct Control dialog box in Xcalibur
 To change the polarity of the remote outputs
1. Install the ChromQuest data system, if you have not already done so.
2. Add the Surveyor PDA Plus Detector to the instrument configuration (see
the Surveyor PDA Plus Detector in ChromQuest"
3. Open the online Instrument window.
4. Choose Control > Instrument Status.
5. Click the Surveyor PDA tab.
6. Click the appropriate button in the Output States area on the PDA detector page.
Connecting Remote Outputs
on page 26).
Surveyor PDA Plus Detector Hardware Manual
2
Installation
"Configuring
21