Powering Off The Ac-Powered Ptx10003 - Juniper PTX10003-80C Hardware Manual

Ensure you do not need to route traffic through the PTX10003.
Ensure you have the following parts and tools available to power off the PTX10003:
An ESD grounding strap
An external management device such as a PC
An RJ-45 to DB-9 rollover cable to connect the external management device to the console port

Powering Off the AC-Powered PTX10003

1. Connect to the router by using one of the following methods:
Connect a management device to the console (CON) port on a PTX10003 by following the instructions
in "Connecting the PTX10003-80C to a Management Console" on page
Connect a management device to one of the two management (MGMT) ports by following the
instructions in "Connecting the PTX10003-80C to a Management Ethernet Device" on page
2. Shut down Junos OS Evolved from the external management device by issuing the request system
shutdown halt operational mode CLI command. This command shuts down Junos OS Evolved gracefully
and preserves system state information. A message appears on the console, confirming that the operating
system has halted.
user@host> request system shutdown halt
Halt the system ? [yes,no] (no) yes
You see the following output (or something similar) after entering the command:
System going down IMMEDIATELY
*** System shutdown message from user@host***
halt the system at Thu Jun 20 04:57:23 2019
user@host> Connection to host closed by remote host.
Connection to host closed.
121.
120.
126