Uninstalling The Ptx10003 - Juniper PTX10003-80C Hardware Manual

Any wear and tear due to frequent plugging and unplugging is then absorbed by the short fiber extension,
which is easier and less expensive to replace than the instruments.
Keep fiber-optic cable connections clean. Microdeposits of oil and dust in the canal of the transceiver
or cable connector can cause loss of light, reduction in signal power, and possibly intermittent problems
with the optical connection.
To clean the transceiver canal, use an appropriate fiber-cleaning device such as RIFOCS Fiber Optic
Adaptor Cleaning Wands (part number 946). Follow the directions in the cleaning kit you use.
After cleaning the transceiver, make sure that the connector tip of the fiber-optic cable is clean. Use
only an approved alcohol-free fiber-optic cable cleaning kit such as the Opptex Cletop-S
Follow the directions in the cleaning kit you use.

Uninstalling the PTX10003

If you need to relocate an installed PTX10003, perform the following procedure.
NOTE: When you remove multiple devices from a rack, remove the device at the top of the rack
first and proceed to remove the rest of the devices from top to bottom to avoid toppling the rack.
Before removing a PTX10003 from a rack:
Ensure that the rack is stable and secured to the building.
Ensure that there is enough space to place the removed PTX10003 in its new location and along the
path to the new location.
Read "General Safety Guidelines and Warnings" on page 175
on page 100.
Power off the device (see
Disconnect the power cords.
Ensure that you have disconnected any cables or wires attached to the PTX10003 (see
a Fiber-Optic Cable from a PTX10003-80C" on page
Here's the parts and tools you'll need to relocate the PTX10003:
Either a mechanical lift or two persons to support the weight of the PTX10003. An additional person is
needed to remove the screws securing the router to the rack.
Screwdriver appropriate for your rack-mounting screws.
"Powering Off the PTX10003" on page
and "PTX10003 Installation Safety Guidelines"
125).
148).
151
®
Fiber Cleaner.
"Disconnecting