Powering Off The Ptx10003 - Juniper PTX10003-80C Hardware Manual

NOTE: The RJ-45 management port is labeled mgmt-0 and the SFP management port is labeled
mgmt-1.
9. (Optional) Configure the static routes to remote prefixes with access to the management port.
[edit]
root@# set routing-instances mgmt_junos routing-options static route remote-prefix next-hop
destination-ip retain no-readvertise
10. Enable the Telnet service.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a PTX10003 through Telnet by using root
credentials. Root login is allowed only for SSH access.
11. Commit the configuration to activate it on the PTX10003.
[edit]
root@# commit

Powering Off the PTX10003

IN THIS SECTION
Powering Off the AC-Powered PTX10003 | 126
Powering Off the DC-Powered PTX10003 | 127
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage.
See "Prevention of Electrostatic Discharge Damage" on page 205.
125