Example: Using Network Ports As 100 Gbps Ethernet Interfaces; Example: Using Network Ports As 200 Gbps Ethernet Interfaces - Juniper PTX10003-80C Hardware Manual

Example: Using Network Ports as 100 Gbps Ethernet Interfaces

0 1
2 x 100G
2 x 100G
QSFP-DD
QSFP-DD
With QSFP28 and QSFP28-DD transceivers, you can configure a 2x100 Gbps data rate on any port. This
is the default port configuration. To attain the maximum 1 Tbps throughput for a port group using 100 Gbps
interfaces, you can configure combinations of 1x100 Gbps, 2x100 Gbps, and 4x100 Gbps data rates. Refer
to Table 7 on page 32.
Table 7: Using Network Ports as 100 Gbps Interfaces
Data Rate QSFP Transceiver
1x100 Gbps QSFP28
2x100 Gbps QSFP28-DD
4x100 Gbps QSFP56-DD

Example: Using Network Ports as 200 Gbps Ethernet Interfaces

0 1
1 x 200G
1 x 200G
QSFP56-DD
QSFP56-DD
With QSFP28-DD transceivers, you can configure select ports in each port group as a 1x200 Gbps Ethernet
interface. To attain the maximum 1 Tbps throughput for a port group, you can configure combinations of
1x400 Gbps, 1x100 Gbps, 2x100 Gbps, and 1x200 Gbps data rates. Refer to
NOTE: The center port in each port group (port 2 and port 7) cannot support 1x200 Gbps. To
configure a 200 Gbps data rate for those ports, you'll need to configure them as 2x100 Gbps.
2 3
2 x 100G
2 x 100G
QSFP-DD
QSFP-DD
Allowable Port
Numbers
0-9
0-9
0, 4, 5, 9
2 3
1 x 200G
2 x 100G
QSFP56-DD
QSFP28-DD QSFP56-DD
4
2 x 100G
QSFP-DD
Maximum Number of
Ports
(PTX10003-160C)
80
160
128
4
1 x 200G
Maximum Number
of Ports
(PTX10003-80C)
40
80
64
Table 8 on page 33.
32