Juniper PTX10003-80C Hardware Manual page 127

Initiating halt... ok
Initiating Junos shutdown...
Shutdown NOW!
ok
Junos shutdown is in progress...
*** FINAL System shutdown message
System going down IMMEDIATELY
...
...
Operating system
Please press any key to reboot.
CAUTION:
command is the "The operating system has halted." Although traffic and the operating
system have stopped, the PTX10003 power supply LEDs remain lit and a fan module
continues to run. Wait at least 60 seconds after first seeing this message before
following continuing with this procedure.
3. To prevent damage to the equipment caused by static discharge, attach an electrostatic discharge (ESD)
grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
4. Turn off the circuit breaker for the DC power source.
CAUTION:
disconnecting the power cord from the power supply. Unplugging an HVDC connection
while the power supply is powered up may damage the electrical connectors.
5. Loosen the thumb screws for the power cable.
6. Disconnect a connector for the power cables or release each of three cables from the power supply
(requires a standard screw driver).
7. Gently pull out the female end of the power cable connected to the power supply.
8. Uncable the device before removing it from the rack.
shutdown: [pid 14318]
***
halted.
The final output of any version of the request system shutdown halt
Turn off the circuit breaker for the HVDC power source before
128