Advertisement
INSTALLATION
Configure for Lock Series
Model 3090-01 used with 4500/4900 Deadlatches (including 8300/8400 Exit Devices):
1. Configure supplied cam plug to match hand of door, see LHR (Figure 3) and RHR (Figure 4).
2. Insert cam plug into latch case with notch aligned to latch set screw.
3. Tighten set screw and secure with two brass cam plug screws (Figure 5).
FIGURE 3: Left Hand Reverse
Model 3090-01 for CVR application using 8500/8600 Exit Devices:
1. Install tailpiece adapter on vertical rod.
2. Fasten with Phillips screw (Figure 6).
Model 3090-01 for RIM application using 8700/8800 Exit Devices:
1. On back of exit device, remove lower screw only to free up cylinder actuator (Figure 7).
FIGURE 7
Model 3090-02 for MS® series Deadlocks:
1. Insert cam plug into lock case with notch aligned to case set screw.
NOTE: Cam Plug must be positioned below door surface.
2. Tighten set screw and secure with two brass cam plug screws (Figure 8).
FIGURE 8
2 of 8
FIGURE 4: Right Hand Reverse
FIGURE 5
Approved 2023-11-13
FIGURE 6: Fasten with Phillips Screw
Advertisement
