Power-Supply Leds; Figure 3-6 The Locations Of The Power-Supply Leds - Huawei Tecal RH5485 Problem Determination And Service Manual

Tecal RH5485 Server
Problem Determination and Service Guide

3.7 Power-supply LEDs

The following minimum configuration is required for the dc LEDs on the power supply to be
lit:




The following minimum configuration is required for the server to start:







If the a MAX5 is connected to the server, two 2 GB DIMMs on the MAX5 memory
expansion module.
The following illustration shows the locations of the power-supply LEDs.

Figure 3-6 the locations of the power-supply LEDs

The following table describes the problems that are indicated by various combinations of the
power-supply LEDs and the power-on LED on the operator information panel and suggested
actions to correct the detected problems.
Issue 02 (2011-05-25)
I/O board
Power supply
Power cord
Microprocessor board
I/O board
Power supply
Power cord
Microprocessor board
One microprocessor
Two DIMMs on one memory card
Operator information panel
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Diagnostics
3-61