Commissioning - Beech ovens E Series Installation And Operation Manual

Beech Ovens
E-Series Manual (R4)

Commissioning

The gas system is a manually controlled system with a pilot, flame failure and electronic
ignition. The flame is ignited manually daily, heating up the oven space on high flame,
then manually adjusting to low flame once the desired (set) temperature is achieved.
As part of connection, the Gas supply lines are to be purged of any air that may be in
the pipes. (Refer to the System Connection section in this manual.)
The following steps are used ONLY to check the ovens general function. Before the
oven may be used for cooking it must undergo a Preheat stage. (Refer to the
Preheating section in this manual)
NOTE: The digital temperature display does NOT control the oven temperature
or any other function other than a temperature display.
Piezo Igniter
(Battery
ON/OFF
behind knob)
Switch
Page 29
Digital
Desired Floor Temperature.
Temperature
(Adjustable, but has NO control function)
Display
2/09/2019 (C)
Confidential and Proprietary
Actual Oven Floor Temperature
Display
Position Mark
Off Position
Pilot Position
High Flame
Position
Low Flame
Position