Pilot And Burner Maintenance; Display Burner - Beech ovens E Series Installation And Operation Manual

Beech Ovens
E-Series Manual (R4)

Pilot and Burner Maintenance

The most common cause of erratic operation of the Gas system is that the Pilot flame
and/or burner becomes contaminated by debris. This may be in the form of foodstuffs
or ash deposited in the area in which the Pilot and/or burner operates.
The following instruction shows the procedure for checking the position of the Pilot
and removal of any debris which may become present around the Pilot and/or
burner. Adjustment should generally not be necessary, though cleaning is common
as part of regular maintenance.
Note: Be sure to turn off the power and Gas before any maintenance takes
place on the oven. Maintenance should be carried out when the oven is cold.

Display Burner

When using a Display burner, wood fuel should NOT be used. However, foodstuffs
and other debris can disrupt the correct operating function of the Pilot on a Display
burner.
If access is not possible through the door, the entire Display burner assembly can be
removed through the base of the oven.
Page 51
Confidential and Proprietary
If the oven is cold and access is
possible, in some cases the Display
burner can be accessed through the
door of the oven. The Tri-electrode is
directly behind the burner shroud.
2/09/2019 (C)