Cable Specifications; Control Input/Output And Control Data - Danfoss VLT AutomationDrive FC 361 Series Design Manual

Specifications
EMC standards, Immunity
Energy efficiency class 1)
1) Determined according to EN 50598-2 at:
•
Rated load.
•
90% rated frequency.
•
Switching frequency factory setting.
•
Switching pattern factory setting.

5.5 Cable Specifications

Cable lengths and cross-sections for control cables
Maximum motor cable length, shielded
Maximum motor cable length, unshielded
Maximum cross-section to motor and mains
Maximum cross-section to control terminals, rigid wire
Maximum cross-section to control terminals, flexible cable
Maximum cross-section to control terminals, cable with enclosed core
Minimum cross-section to control terminals
1) For power cables, see electrical data in chapter 5.1 Electrical Data, 380-480 V.

5.6 Control Input/Output and Control Data

Digital inputs
Programmable digital inputs
Terminal number
Logic
Voltage level
Voltage level, logic 0 PNP
Voltage level, logic 1 PNP
Voltage level, logic 0 NPN
Voltage level, logic 1 NPN
Maximum voltage on input
Input resistance, R
i
All digital inputs are galvanically isolated from the supply voltage (PELV) and other high-voltage terminals.
1) Terminals 27 and 29 can also be programmed as outputs.
Analog inputs
Number of analog inputs
Terminal number
Modes
Mode select
Voltage mode
Voltage level
Input resistance, R
i
Maximum voltage
Current mode
Current level
Input resistance, R
i
Maximum current
Resolution for analog inputs
Accuracy of analog inputs
Bandwidth
The analog inputs are galvanically isolated from the supply voltage (PELV) and other high-voltage terminals.
MG06K102
Design Guide
Danfoss A/S © 03/2019 All rights reserved.
150 m (492 ft)
300 m (984 ft)
See chapter 5.1 Electrical Data, 380-480 V
2
1.5 mm /16 AWG (2x0.75 mm
1 mm
0.5 mm
0.25 mm
18, 19, 27 1)
Approximately 4 kΩ
Voltage or current
Switches A53 and A54
Switch A53/A54=(U)
0 V to +10 V (scaleable)
Approximately 10 kΩ
Switch A53/A54=(I)
0/4 to 20 mA (scaleable)
Approximately 200 Ω
10 bit (+ sign)
Maximum error 0.5% of full scale
EN 61800-3
IE2
5 5
1)
2
)
2
/18 AWG
2
/20 AWG
2 /23 AWG
4 (6)
, 29 1) , 32, 33
PNP or NPN
0–24 V DC
<5 V DC
>10 V DC
>19 V DC
<14 V DC
28 V DC
2
53, 54
±20 V
30 mA
100 Hz
19