Mechanical Installation Considerations; Storage; Lifting The Unit - Danfoss VLT AutomationDrive FC 361 Series Design Manual

Mechanical Installation Con...

6 Mechanical Installation Considerations

6.1 Storage

Store the drive in a dry location. Keep the equipment
sealed in its packaging until installation. Refer to
chapter 5.4 Ambient Conditions for recommended ambient
temperature.
Periodic forming (capacitor charging) is not necessary
during storage unless storage exceeds 12 months.

6.2 Lifting the Unit

Always lift the drive using the dedicated lifting eyes. To
avoid bending the lifting holes, use a bar.
WARNING
RISK OF INJURY OR DEATH
Follow local safety regulations for lifting heavy weights.
Failure to follow recommendations and local safety
regulations can result in death or serious injury.
•
Ensure that the lifting equipment is in proper
working condition.
•
See chapter 3 Product Overview and Features for
the weight of the different enclosure sizes.
•
Maximum diameter for bar: 20 mm (0.8 in).
•
The angle from the top of the drive to the
lifting cable: 60° or greater.
MG06K102
Design Guide
65° min
Illustration 6.1 Recommended Lifting Method
Danfoss A/S © 03/2019 All rights reserved.
6 6
33