IBM System Storage TS7600 ProtecTIER Series Installation Roadmap Manual page 125

Site 2 – Server A
2 (eth4)
Site 2 – Server B
ID
1 (eth3)
2 (eth4)
19. Type: q <enter>
20. Type: yes <enter>.
21. Verify that Server B was automatically added as a cluster member. To do so:
Target Network Address
(Remote node's starting
network address)
The Available Options prompt displays a third time:
Available Options:
==================
(a)dd a new record
(e)dit a record
(d)elete a record
(c)ommit changes
(q)uit
Please Choose (a,e,d,c,q):
The message below displays:
Would you like to commit the changes performed to the routing table
now? (yes|no)
The Successfully committed changes! message displays, and you are
returned to the command prompt.
Server B should now appear as a cluster member in the ProtecTIER Manager
GUI.
Note: This is only true if the repository was created before configuring the
second node.
a. At the ProtecTIER Manager workstation, in the PT Systems tab of the
Navigation pane, select Server A.
b. Log in to Server A with the username ptadmin and password ptadmin.
In the Servers pane, verify that the IP addresses of both Server A and
Server B, display. See Figure 32 on page 90.
Target Netmask
(Remote node's netmask)
Chapter 12. Upgrading ProtecTIER to a cluster
Local Gateway Address
(The gateway address for
Server B at Site 2)
89